After few crashes, the flying wing V1.0 wasn’t able to rich the same performance as it did in the beginning, so I came up with V2.0 (not necessary better, but the build took only 1 hour) and I got up in the air again.
And of course, the crash:
Category: Flying wing
V1.0
After the flying wing project from TU Delft – semester 1, I decided I should build my own wing with the skills achieved. So I designed it with the following specifications:
- Wing span: 8500mm
- Sweep angle: 30°
- Taper ratio: 1.2
- Propeller: 8″
- Motor: 1400kV, 210W
- Accumulator: 2x3S (11.1V) 1100mA
And before the first crash:
Unfortunately, I couldn’t film the crashes but I can tell that I had a lot of fun building and piloting it.
Vlad Petrescu 